| About the LIGER Gun Belt
The LIGER Gun Belt represents a major break-through in gun belt design,
utilizing custom components and proprietary processes developed by and available
exclusively from EDGYGEAR INC.
Ligerthane Belt Material
The Ligerthane belt material is a 21st century composite developed by EDGYGEAR
INC. Thanks to its high-strength resin-embedded polyester fabric core,
Ligerthane possesses over 2,000 lbs of tensile strength with over 300 lbs of
hole pull strength. The highly abrasion-resistant polyurethane coating makes the
belt totally impervious to salt water, blood, mildew, mold, rot and resistant to
many common solvents. Ligerthane is flexible along its length for comfort yet
stiff along its width so you can carry holsters, sheaths, or pouches without the
belt sagging or twisting. Ligerthane has a super grip interior so the belt and
any belt holstered items stay put while the LigerDerm patterned exterior imparts
a supple, organic appearance. The LIGER™ Gun Belt is tough enough to wear with
your BDU’s but attractive enough for dress slacks making it ideal for discreet
CCW. Best of all, Ligerthane is easy-to-clean, just rinse with mild detergent
and wipe dry.
LIGER Buckle and Construction
The LIGER Gun Belt buckle is painstakingly machined from a solid billet of
T6-6061 aircraft aluminum with our exclusive integral LigerTooth hook design. In
other words, the hook is part of the same piece of material as the buckle (NOT
plugged or glued in, NOT brazed or welded on) After a two-step finishing
process, Type-III hard-anodized finish (MILSPEC-A-8625) is applied for
incredible wear resistance. The LIGER™ buckle and Ligerthane belt are riveted
together using robust 3/16” stainless steel rivets resulting in a strong,
permanent one-piece construction.
Sizing Instructions
LIGER belt sizing is based on ACTUAL WAIST CIRCUMFERENCE in inches. Each belt is
handmade one at a time upon receipt of order based on the sizing information you
provide. In order to prevent ordering an incorrect size and to insure a tailored
fit, please carefully read the following simple measuring instructions:
1. Do NOT order according to your pants size. Please measure your waist
circumference in inches with a cloth tailor’s tape (or a measuring tape).
2. Put the tape through the loops on your pants as you would usually wear them,
measuring all the way around your waist with any equipment you wear on your belt
or inside your waist band like guns, knives, phones, pouches, etc.
3. This waist circumference measurement is your belt size and should be the
location of your primary hole. If you measure an odd number (ex: 41 inches),
order the next higher even number size (Size 42).
4. Each belt comes with six (6) pre-punched holes. Besides your primary hole, we
provide two additional holes going smaller and three additional holes going
larger at one (1") inch increments for fine adjustment.
5. Each belt is custom built to order and components are permanently rivetted
together, consuming the components and rendering them impossible to reuse. A
twenty-five percent (25%) restocking fee will be charged for items returned for
incorrect sizing
Product Warranty
EDGYGEAR INC. extends a limited lifetime warranty covering all products against
manufacturer’s defects including flaws in material and workmanship. Products
covered under our warranty will be repaired or replaced at our discretion, free
of charge. This limited lifetime warranty does not cover misuse, abuse, or
normal wear and tear |
